Folks,
I have a reasonable stash of AA brass and have been wondering about flash hole sizes. As delivered it's just shy of .059 and won't allow the guide on a lee case gauge or the decapping pin of my lee decapping die through. The tips of the gauge and the pin are about .061. K&M Shooting makes a nice flash hole uniformer that's .062. Anybody use one of these?
I'm not all that worried about case lengths, but I do sorta like making sure they're reasonably close the same length for the sake of consistency and I like using the stand alone decapping die.
I know I could chuck the gauge and pin in a drill press and sand the diameter a bit. Just curious.
I have a reasonable stash of AA brass and have been wondering about flash hole sizes. As delivered it's just shy of .059 and won't allow the guide on a lee case gauge or the decapping pin of my lee decapping die through. The tips of the gauge and the pin are about .061. K&M Shooting makes a nice flash hole uniformer that's .062. Anybody use one of these?
I'm not all that worried about case lengths, but I do sorta like making sure they're reasonably close the same length for the sake of consistency and I like using the stand alone decapping die.
I know I could chuck the gauge and pin in a drill press and sand the diameter a bit. Just curious.
Comment