I have been purchasing factory loads. With the lack of options currently in the market place and sitting on shelves, the obvious solution to stay in supplies of ammunition is to start reloading. Never before have I had any dealings with reloading but am accustomed to measuring chemicals and keeping within tight variables when building rocket motors.
So to get to the piont, is there anyone that is in the Dallas area or close to (Richardson, plano, Garland, Sachse) area that would be willing to show me a typical setup and run through the process of reloading cartridges?
Seeing the process and required equipment needed to complete the reload I figure would be easier to understand than trying to figure it out from online documents. Understanding one will not fully gain all the knowledge needed in one sitting but it sure would help knock the edge off of getting started.
So to get to the piont, is there anyone that is in the Dallas area or close to (Richardson, plano, Garland, Sachse) area that would be willing to show me a typical setup and run through the process of reloading cartridges?
Seeing the process and required equipment needed to complete the reload I figure would be easier to understand than trying to figure it out from online documents. Understanding one will not fully gain all the knowledge needed in one sitting but it sure would help knock the edge off of getting started.
Comment