If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Thank you, and thanks to everyone else. I spent a couple of hours on google earlier with 'rcbs shell holder grendel' and any variation I could think of, and the information was conflicting at best. Someone (AA) should probably put some effort into providing information for reloaders.
The easiest way to figure it out is to take your grendel brass with you into your local sportsmans/gun store and just try a couple till you find on that fits just right.
When I started loading for the Grendel, I wondered the same thing. I looked in the Speer manual (an RCBS/Omark/CCI partner) and saw that they show a #32 for the 7.62x39. Since the Grendel case is supposed to be based on that parent case I surmised that it should be appropriate. I already had that shellholder since I reload for a Ruger Mini-30. At any rate, the RCBS #32 has been working for me and my new Grendel.
ETA-- I also used the same logic to find an appropriate shellholder for my Lee Auto-Prime hand priming tool. Use the one they have listed for the 7.62x39; it works for me!
Comment