Forum: 6.5 Grendel Troubleshooting

what is the desired...or is there one point or general direction of brass ejection...my gun is different from my brothers and they are both...

Okay we have a problem. My brothers grendel has. A live round stuck in the chamber. We shot 18 of the very same hand load and no hiccups. The...

Folks, I'm very frustrated with my Grendel build. Finished building it in February of this year, but haven't had a lot of time to shoot it. Range...

New Upper. New BCG. Using two (2) lowers, each of which is known to work (4000 rounds thru one, about 1200 thru the other). Same problem. ...

I have been trying to get my Grendel to feed & fire reliably without much success. I have been using Hornady brass, 123g AMax bullets, and some...

I running a 16" Liberty barrel (carbine gas), and when ever I try using the Wolf 120gr MPTs, about 1 in 4 will snag on the feed ramps outside the...

I have an AA 14.5" upper that intermittently (25% of the time) fails to feed. The symptoms are a round stuck at 45 degrees with tip of the bullet in...

When I bought my first 16" for defense, The accuracy was plenty good for my purposes. Have shot the heck out of it with about 1.25 - 1.50 moa. Then...

My Grendel has too little headspace, and I have a chrome lined Sabre Defense barrel. I believe Sabre is out of business. Since the barrel is...

One of the biggest pitfalls to this caliber is the Magazine and feeding issues. On the old site,there was a thread on proper magazine tuning with...

Hello, I finally got a chance to go the the range. Great shooting rifle, but it is not extracting the empty brass? I had to tug on the charging...

Okay so now I have my gun done. New narrel from mr a himself. I run 15 rounds am nothing as far as cleaning. What is proper schedule on this new...

Ok so I got the bolt issue fixed all is well. The problem I am having now is the bolt will not cycle back and lock. I adjusted the gas block and...

Hey guys just got first build done went to shoot today and loaded one round in mag pulled CH back and bolt would not close all the way,if I locked...

I went and fired my new Grendel today and it worked perfectly. The brass on the other hand has this little ding in it. Each was exactly the same. ...

I was shooting my Grendel today and had 4 out of 8 primers pierced. I did look at the first 2 cases they were fine. I didn't notice the problem til I...

I just noticed that my gas block set screws are touching my hand guard. It is a YH low profile clamp on gas block. The hand guard I am using is the...

I have been off line for qiute awhile. Did a motoecycle rde from sea to shining sea for diabetes research and some other things this year. Anyhow I...