+ Post New Thread
Page 1 of 127 1 2 3 11 51 101 ... LastLast
Threads 1 to 20 of 2532

Forum: 6.5 Grendel Ammunition & Reloading

Discuss 6.5 Grendel handloading data as well as official SAAMI 6.5 Grendel factory ammunition. Any new threads about specific bullets or powders should have that name in the title, otherwise add to existing threads dedicated to specific bullets or powders.

  1. Sticky Thread Sticky: Grendel bullet PDF

    By Name: https://dl.dropboxusercontent.com/u/34132774/Grendel%20Bullet%20List%20Alpha%20April2013.pdf By weight:...

    Started by bwaites, 05-16-2012 10:30 PM
    4 Pages
    1 2 3 ... 4
    • Replies: 37
    • Views: 28,127
    08-11-2016 03:10 PM Go to last post
  2. Sticky Thread Sticky: 6.5 Grendel Preferred Loads

    I think the 6.5 Grendel is a fantastic cartridge, mild but yet effective over a wide range of conditions, and of course the fact it fits into the AR...

    Started by stokesrj, 09-15-2012 10:33 PM
    25 Pages
    1 2 3 ... 25
    • Replies: 249
    • Views: 153,402
    07-27-2016 02:42 AM Go to last post
  3. Sticky Thread Sticky: Updated Selection of Projectiles for the Grendel

    Here is an updated list of projectiles ranging from 85gr-130gr. Since a few hunters have seen great results with 140gr bullets, and the 160gr are...

    Started by LRRPF52, 02-29-2012 12:10 AM
    19 Pages
    1 2 3 ... 19
    • Replies: 182
    • Views: 50,979
    04-30-2016 12:57 PM Go to last post
  4. Sticky Thread Sticky: What presses and dies are you using and general equipment recommendations.

    Doing some reading here, researching and learning, as I put together my first Grendel. Just wondering what presses and dies everybody is using. I...

    Started by 1075 tech, 11-28-2015 12:14 PM
    4 Pages
    1 2 3 ... 4
    • Replies: 35
    • Views: 7,390
    03-16-2016 02:21 AM Go to last post
  5. Sticky Thread Sticky: BFT's Lengthy List of Loads

    Whenever I run across a 6.5 Grendel load — here or on other forums — that seems reasonable and from a responsible reloader who carefully inspects...

    Started by BluntForceTrauma, 02-25-2016 04:42 AM
    • Replies: 0
    • Views: 2,060
    02-25-2016 04:42 AM Go to last post
  6. Sticky Thread Sticky: Factory Reloading Resources

    Alexander Arms http://www.alexanderarms.com/images/pdfs/grendel_reloading.pdf Hodgdon http://data.hodgdon.com/cartridge_load.asp Ramshot...

    Started by bwaites, 03-17-2011 04:12 AM
    3 Pages
    1 2 3
    • Replies: 27
    • Views: 29,439
    01-12-2016 05:54 PM Go to last post
  7. Sticky Thread Sticky: www.Grendeldata.com

    I keep getting PM's asking where the post about Grendel Data went. It is a commercial venture, so it is in slot in the Partners forum, but it also is...

    Started by bwaites, 03-31-2015 04:10 PM
    • Replies: 3
    • Views: 5,077
    12-29-2015 09:14 PM Go to last post
  8. Sticky Thread Sticky: Official SAAMI and CIP 6.5 Grendel Drawings

    Official SAAMI and CIP 6.5 Grendel cartridge and chamber specifications.

    Started by BluntForceTrauma, 02-19-2014 03:02 PM
    • Replies: 0
    • Views: 7,909
    02-19-2014 03:02 PM Go to last post
  9. Sticky Thread Sticky: Reloading data from the old site

    Here is the reloading data from the old 6.5 Grendel forum. USE WITH CAUTION AND ON YOUR DISCRETION. I CAN NOT VOUCH FOR THE ACCURACY OF THE POSTED...

    Started by infidel470, 03-09-2011 05:36 AM
    3 Pages
    1 2 3
    • Replies: 25
    • Views: 37,107
    01-02-2014 03:57 PM Go to last post
  1. Cool 143gr ELD-X and 123gr SST's with LeverEvolution.

    Special thanks goes to Glock357 as he gave me some 143gr ELD-X bullets for this test. 20" BHW Barrel 1:8 twist using PPU brass First up 143gr...

    Started by 6.5 Grendel, Yesterday 11:20 PM
    • Replies: 1
    • Views: 26
    Today 02:22 AM Go to last post
  2. Rumor- PRVI dropping their Grendel loads?

    Saw a comment from someone at SGAMMO that claimed PRVI was getting out of Grendel. Seems unlikely, but dies anyone have any concrete information...

    Started by Grendelsbane, 08-26-2016 03:09 PM
    2 Pages
    1 2
    • Replies: 12
    • Views: 346
    Today 02:06 AM Go to last post
  3. Berger 6.5mm 130gr Hybrid bullet

    Has any one loaded and shot these in a Grendel? Thanks

    Started by lrgrendel, 08-25-2016 07:55 AM
    • Replies: 3
    • Views: 185
    08-26-2016 11:53 PM Go to last post
  4. 120gr. GMX load

    Anybody has a good load for 120gr. gmx ? Here in CA we have to use leadfree bullet in the condor zone and pretty soon it will be leadfree statewide....

    Started by coyotetan, 08-23-2016 10:37 PM
    • Replies: 5
    • Views: 233
    08-26-2016 06:22 PM Go to last post
  5. The NEW Accurate 2520

    As already posted 2520 is finally available, but it is "New" 2520. No longer made in Belgium, made in USA. Anyone have a chance to try the "new"...

    Started by mseric, 08-08-2016 04:21 PM
    3 Pages
    1 2 3
    • Replies: 21
    • Views: 1,036
    08-26-2016 03:55 AM Go to last post
  6. AA E-Lander magazines?

    I ordered some back in June and I haven't seen them yet. I was wondering if anyone has received or reviewed them yet. TIA, Will

    Started by WillD, 08-09-2016 02:13 PM
    2 Pages
    1 2
    • Replies: 12
    • Views: 647
    08-26-2016 02:34 AM Go to last post
  7. Factory ammo then maybe reload

    New to the grendel.. just picked up a Lilja 18 in barrel in 1-8 twist.. was going to try factory hornady 123 amax and see how well it groups and to...

    Started by Daniel1381, 08-25-2016 02:49 AM
    • Replies: 2
    • Views: 86
    08-25-2016 02:56 AM Go to last post
  8. 123 amax with AR Comp report

    This has pretty much become my go to load for this rifle (Lilja 23 inch). In may I ran several shots of this load through my Chrony with the...

    Started by GarandThumb, 07-17-2016 05:52 AM
    2 Pages
    1 2
    123 amax, ar-comp
    • Replies: 10
    • Views: 1,194
    08-21-2016 11:45 PM Go to last post
  9. Barnes 120 gr TTSX

    Has anyone got a go-to load using this bullet? I've experimented with Varget and Benchmark powders and bullet seating depths between 0.030" and...

    Started by For Gallantry, 07-30-2016 05:42 PM
    • Replies: 9
    • Views: 813
    08-21-2016 01:51 AM Go to last post
  10. wolf small rifle magnum primers?

    i have grown used to using them, consistant, reliable and actually were pretty cheap! but i cannot find them for sale anymore,,,,,anyone know where...

    Started by dammitman, 08-20-2016 01:32 PM
    • Replies: 6
    • Views: 192
    08-21-2016 12:18 AM Go to last post
  11. Worlds finest trimmer, 6.5 Grendel, ok for Creedmoor?

    Folks, Worlds finest trimmer, 6.5 Grendel, ok for Creedmoor? A2

    Started by usmcm16a2, 08-19-2016 06:59 PM
    • Replies: 1
    • Views: 191
    08-19-2016 08:05 PM Go to last post
  12. This Old Bottle

    Guess I'm a little late posting this note, given that AA2520 is back on the market....

    Started by rickOshay, 06-21-2016 01:53 AM
    • Replies: 5
    • Views: 583
    08-18-2016 03:12 AM Go to last post
  13. IMR 4166 revisiting with 129 grain projectile

    I see Nozzler is listing load data for 129 grain projectile And listing IMR 4166 as their most accurate propellant Tested. Anyone been trying IMR...

    Started by SD GUY, 08-14-2016 01:57 PM
    • Replies: 3
    • Views: 195
    08-15-2016 03:48 AM Go to last post
  14. New to 6.5 Grendel Reloading - shoulder collapsing while sizing

    I'm new to reloading 6.5 Grendel but have reloaded both 308 and 223 for a while. I bought the Forster Bench Rest full length sizer because I...

    Started by StoneHendge, 08-14-2016 10:58 PM
    • Replies: 7
    • Views: 282
    08-15-2016 03:43 AM Go to last post
  15. IMR 4895 + Hornady A Max

    Has anyone here used the combination of IMR 4895 and 123 grain Hornady A Max bullets? I have a couple of pounds of the IMR and thought that I might...

    Started by Retro, 08-11-2016 09:56 PM
    • Replies: 9
    • Views: 383
    08-14-2016 01:20 AM Go to last post
  16. Dies for .264 LBC Grendel Type 1 .125 Headspace

    Hello, I am new to reloading and am beginning to assemble the gear I need to get going. I plan on reloading 6.5 Grendel to shoot out of my .264 LBC...

    Started by DenverDave, 08-12-2016 04:36 AM
    2 Pages
    1 2
    • Replies: 11
    • Views: 356
    08-13-2016 03:21 PM Go to last post
  17. 125 partititon lever data

    Have been trying to find a load for this bullet without much success. Ran a ladder with lever up to 31.8 gr. I was testing multiple rifles and...

    Started by Cornbread, 08-09-2016 03:13 PM
    • Replies: 4
    • Views: 264
    08-12-2016 03:37 PM Go to last post
  18. Handloads and range report: Hornady ELD-X 143 gr and A-max 123 gr with CFE 223

    After reviewing a multitude of threads from this forum and collecting load data suggestions from prominent members I loaded two bullets the Hornady...

    Started by Glock357, 08-07-2016 07:14 PM
    3 Pages
    1 2 3
    • Replies: 21
    • Views: 1,018
    08-11-2016 03:10 AM Go to last post
  19. First test with XBR and 123 Amax???

    Alright guys, started load testing yesterday. Not sure what to think yet. 24" AA upper 123 AMax XBR Hornady brass CCI 450 Temp-85 deg...

    Started by Shoot1jmk, 07-16-2016 05:13 PM
    • Replies: 6
    • Views: 639
    08-09-2016 01:59 AM Go to last post
  20. New to Grendel - Why the QL difference between SAAMI and CIP?

    Greetings all and thanks for the view. I am new to the Grendel but not to reloading, for example have done some OBT stuff to work up a Tikka Lite in...

    Started by DDBTx, 07-19-2016 04:38 AM
    2 Pages
    1 2
    • Replies: 11
    • Views: 617
    08-08-2016 06:09 PM Go to last post

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts