Vag,
Perhaps then the machine's calibration is out. Fixed by warranty repair.
There are videos on YT comparing velocities from...
User Profile
Collapse
-
Acquisition angle of the Garmin is 12 degrees.
Was incrementally angling the Garmin away from the bore axis until it no longer picked up...
Leave a comment:
-
-
Vag,
50fps lower when the other two were identical does sound like something's wrong with the Garmin. Did you have both radars on at the...Last edited by Klem; Yesterday, 03:28 AM.
Leave a comment:
-
-
Gofast,
I work in percentages so it is relative across different size calibres and cases.
Figure out what the max safe load...
Leave a comment:
-
-
bmash,
Sure you can use it, but it's not the most efficient powder for a 120gn bullet
Manufacturers post data for a range of...Last edited by Klem; 03-21-2024, 08:42 AM.
Leave a comment:
-
-
Coop,
ADI's single-based (temp stable) powders suitable for the Grendel are 8208 for under 120gn, and H4895 for 120gn and heavier. I recommend...Last edited by Klem; 03-20-2024, 06:19 AM.
Leave a comment:
-
-
Cav,
Your expectations of 0.5MOA are with respect, unreasonable in an AR. A few groups in every session will be 0.5, but the average is going...Last edited by Klem; 03-17-2024, 05:56 AM.
Leave a comment:
-
-
Cav,
Best I can get is 0.8MOA on average.
Data is attached and has been posted previously. It was testing crimping vs.neck tension....You do not have permission to view this gallery.
This gallery has 1 photos.Last edited by Klem; 03-16-2024, 10:21 AM.
Leave a comment:
-
-
Cav,
Yes, there are other reasons for case bulging, as seen in the photos. Headspace can be fine however the case gets dragged out before...
Leave a comment:
-
-
-
Lazy.
Yes, I've had Muvef's situation in 223. Hot hand-loads extruded the web into the bolt face, to the point the spent case rims could...
-
👍 1
Leave a comment:
-
-
Joe,
OK, that eliminates all the usual suspects related to hand-loading.
From the photo it looks like an OOB or out-of-battery...
Leave a comment:
-
-
Joe,
Are these hand-loads or factory ammo?
Do any of the other cases show any symptoms, even lesser bulges down at the web?...
Leave a comment:
-
-
Those are hot loads for LVR and that bullet, even at a long OAL like 58mm.
I have not used this powder but would not go over 29.5. Unless...Last edited by Klem; 03-11-2024, 12:52 AM.
Leave a comment:
-
No activity results to display
Show More
Leave a comment: