If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I have been using standard CCI LRP for stick powder and magnum CCI LRP for ball powder. They all have been working close to the estimated velocities. I am not pushing the higher pressure rounds at this time. I saw no difference from PPU vs other brass at the medium loads.
Oh - and I also have the slightly longer firing pin used for 7.62x39 military primers. I polished the end of the pin with Flitz to remove any sharp edges. No pierced primers so far.
Comment