Folks,
I had my Grendel out to the range today (and, as an aside, it sure is cold over here on Bill's side of the mountains). I tried running it with my TBAC 30P1, but that didn't work. Lots of issues with that.
After I took the suppressor off, I was still experiencing failure to feed issues. I was using Hornady 123 gr AMAX rounds, the the plastic points were jammed/bent when a malf occurred.
Any thoughts on what could be the issue? I'm running an H1 buffer with a 16 inch BHW barrel and, I think, a carbine length gas system.
On the plus side, I was able to get hits on steel out to 900 yards. At 1000 yards, the snow was swallowing my misses and my wife couldn't spot my misses to give me a good wind correction.
I had my Grendel out to the range today (and, as an aside, it sure is cold over here on Bill's side of the mountains). I tried running it with my TBAC 30P1, but that didn't work. Lots of issues with that.
After I took the suppressor off, I was still experiencing failure to feed issues. I was using Hornady 123 gr AMAX rounds, the the plastic points were jammed/bent when a malf occurred.
Any thoughts on what could be the issue? I'm running an H1 buffer with a 16 inch BHW barrel and, I think, a carbine length gas system.
On the plus side, I was able to get hits on steel out to 900 yards. At 1000 yards, the snow was swallowing my misses and my wife couldn't spot my misses to give me a good wind correction.
Comment