If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I would just get a good wrench and a reaction/extension rod and some of the proper punches.
. (http://www.brownells.com/gunsmith-to...7cMake_3=AR-15)
The plastic clam shells do not fit many of the billet uppers, I have not used the clam shell in years. The reaction rod works great, as long
as you have a good vise to use.
Great question, Ed. I've been working on ARs for about 4 years now and I've never been satisfied with my receiver clamshell. I'm seriously considering dropping the coin on a Geissele Reaction Rod this coming Black Friday. At first blush it seems like a lot of money for what it is yet it seems to be getting good reviews.
Wow fly guy I do live in AZ but my nieces husband had an upper block that fit top and bottom of the receiver that worked just fine for installing the barrel and the flash hider. I am considering buying him the Brownell rod for Xmas.
Wow fly guy I do live in AZ but my nieces husband had an upper block that fit top and bottom of the receiver that worked just fine for installing the barrel and the flash hider. I am considering buying him the Brownell rod for Xmas.
Don't use a clam shell or receiver block or reaction rod installing a flash hider. Use a barrel clamp.
Because you are now placing torque on the barrel and barrel extension, not just the barrel.
Anytime you're doing muzzle device work, clamp the barrel only, never the upper receiver.
A common principle in tool use/applied physics, is to isolate the work to the parts being worked on, without introducing other components into the mix.
NRA Basic, Pistol, Rifle, Shotgun, RSO
CCW, CQM, DM, Long Range Rifle Instructor
6.5 Grendel Reloading Handbooks & chamber brushes can be found here:
Are there any vises that don't require bolting to a workbench (and punching holes in it) but instead use a clamp style to tighten the fit to the table?
Are there any vises that don't require bolting to a workbench (and punching holes in it) but instead use a clamp style to tighten the fit to the table?
you are speaking of a barrel vice right? this is the one I use. I have a black & decker workmate that I clamp it to. couple of C clamps is all it takes. I have a savage switchbarrel and change them around quite often. I wrap my barrel with a leather strap to protect it and give a better grip. they do make wooden vice blocks that will do the same.
I am sure someone will chime in with a homemade one in a minute. Nothing wrong with that either. I like mine because it is pretty.
Are there any vises that don't require bolting to a workbench (and punching holes in it) but instead use a clamp style to tighten the fit to the table?
Yes, I have no experience with them so I don't know how well they work, but I don't see why they wouldn't.
This one is pretty cheap and it's big enough to work on an AR. Just make sure your bench is solid.
Comment