Have an interesting sizing problem when I reload. I have applied lube but still shaving brass and doesn't appear to go all the way down to the extractor groove, and the base extends about .001" beyond the spec per the Lee case gauge. Anyone have thoughts?
Sized not over-cammed: http://imgur.com/eqRoINm
Sized over-cammed: http://imgur.com/trzrFID
Both have same overall length; Left -Fits in Gage but possibly over bumped; Right - slightly protrudes from bottom: http://imgur.com/nH3Wjf9
In a comparator the left is .012" longer than right, and the case gauge has a difference of .015" between the go and no go.
Better view of bulge starting to shear: http://imgur.com/Ua6b5Z7
.442" vs .446" - .004" difference in the web bulge
If I complete full cam, the sheer becomes too wide to even fit in the case gage and is unuseable
Sized not over-cammed: http://imgur.com/eqRoINm
Sized over-cammed: http://imgur.com/trzrFID
Both have same overall length; Left -Fits in Gage but possibly over bumped; Right - slightly protrudes from bottom: http://imgur.com/nH3Wjf9
In a comparator the left is .012" longer than right, and the case gauge has a difference of .015" between the go and no go.
Better view of bulge starting to shear: http://imgur.com/Ua6b5Z7
.442" vs .446" - .004" difference in the web bulge
If I complete full cam, the sheer becomes too wide to even fit in the case gage and is unuseable
Comment