Is it something special? We have lapping compound at work for engine valves, similar stuff or too aggressive?
Upper reciever lapping compound
Collapse
X
-
The lil bottle that came with the lapping tool say's 220 grit on the top so it doesn't seem to be to much of a heavy compound, would think valve lapping compound would work fine as well.
Don't forget to lube the shaft of the tool with a good oil when you go to lapp the reciver.Last edited by A5BLASTER; 04-24-2017, 03:37 AM.
Comment
-
-
Originally posted by A5BLASTER View PostIt's cool always time for a good laugh.
I'm at the range today doing a lil trigger workout with the rifle, started at 100 went to 200 then 300 then 400, I will post up a few pkics of the targets, JP 18inch barrel and I have bonded well.
Comment
-
-
It was fun but i forgot to take some pics of the groups.
Wind wasn't bad today for me but the bench and bench set up is awful at the range I went to not to mention I couldn't get my head out my rearend long enough today to shoot any groups worth looking at.
Best group I did might have been ten rounds fired twenty seconds apart between each round at a 100 that was under two inches.
Comment
-
Comment