To make a long story short, I have come to the realization that the gas port on my custom barrel does not seem to be aligned with the barrel extension locating pin. To get the gun to run 100% I have to fudge the gas block sideways a bit. That obviously means my gas tube is not centered in the receiver and drags on the gas key.
I figure that can't be good for accuracy. Is there a fix? Trying to decide if I want to live with it or contact the shop I bought the barrel from. The barrel shoots ok but is not the tack driver I expected.
Thanks for any input.
I figure that can't be good for accuracy. Is there a fix? Trying to decide if I want to live with it or contact the shop I bought the barrel from. The barrel shoots ok but is not the tack driver I expected.
Thanks for any input.
Comment