I've been planning this for quite some time and it's finally coming together.
Specs
Upper-
Sabre Defence 14.5" barrel cut to 12.5" and threaded to 5/8"x24
BCM blem receiver
AA hard use bolt (unsure of carrier manuf.)
BCM MKR10 handguard- REALLY liking this one- super light and great profile. Seriously considering switching everything to it.
Micromoa Govnah switchable gas block
YHM QD break for the Ti 7.62 can I have in ATF jail.
MI keymod grip panels
PRI Gasbuster charging handle
Optic-
1-4 VX-R ballistic firedot in Larue mount- Still undecided if this is going to stay or go to a 2-7.
Lower-
RRA SBR'd receiver
RRA NM 2 stage trigger
Magpul CTR stock
Hogue ghillie tan grip
BAD lever
Base coat of Duracoat Tactical Dark Earth. Camo pattern will be done soon.
Mockup before cut down
Lathe setup- I'm NOT a gunsmith or machinist. I know just enough to make chips and get myself in trouble sometimes.
2" removed
Continued...
Specs
Upper-
Sabre Defence 14.5" barrel cut to 12.5" and threaded to 5/8"x24
BCM blem receiver
AA hard use bolt (unsure of carrier manuf.)
BCM MKR10 handguard- REALLY liking this one- super light and great profile. Seriously considering switching everything to it.
Micromoa Govnah switchable gas block
YHM QD break for the Ti 7.62 can I have in ATF jail.
MI keymod grip panels
PRI Gasbuster charging handle
Optic-
1-4 VX-R ballistic firedot in Larue mount- Still undecided if this is going to stay or go to a 2-7.
Lower-
RRA SBR'd receiver
RRA NM 2 stage trigger
Magpul CTR stock
Hogue ghillie tan grip
BAD lever
Base coat of Duracoat Tactical Dark Earth. Camo pattern will be done soon.
Mockup before cut down
Lathe setup- I'm NOT a gunsmith or machinist. I know just enough to make chips and get myself in trouble sometimes.
2" removed
Continued...
Comment