+- 6.5 Grendel Forum (https://65grendel.com)
+-- Forum: 6.5 GRENDEL DISCUSSION FORUMS (https://65grendel.com/forumdisplay.php?fid=3)
+--- Forum: 6.5 Grendel Target & Competition Shooting (https://65grendel.com/forumdisplay.php?fid=12)
+--- Thread: Breaking in a New Barrel and Cleaning (/showthread.php?tid=10853)
Breaking in a New Barrel and Cleaning - ppierceall - 02-25-2016
I just ordered a new 6.5 Grendel Upper from Precision Firearms - For those who compete what is your procedure of breaking in a new barrel and cleaning. With my AR15 I use a bore snake with Gun Scrubber and G96. But I am sure with my 6.5 set up there may be a better way.
Breaking in a New Barrel and Cleaning - am4966 - 02-25-2016
PF might send barrel break in, if not you can go to the barrel mfg website for suggestions.
I use a Dewey rod with the Vfg adapter and pellets. Solvents will be Frog Lube and if that doesn't work, then I'll go back to Fireclean. In my match barrels I won't use a wire brush in the bore. Maybe it's just me...
Breaking in a New Barrel and Cleaning - LR1955 - 02-25-2016
ppierceall Wrote:I just ordered a new 6.5 Grendel Upper from Precision Firearms - For those who compete what is your procedure of breaking in a new barrel and cleaning. With my AR15 I use a bore snake with Gun Scrubber and G96. But I am sure with my 6.5 set up there may be a better way.
What you are doing is fine.
Once every couple hundred rounds you should probably break the AR down and clean in a conventional manner using rods, patches, and brushes. More so to clean the bolt and carrier and to inspect gas rings and cam pin than much else.
If you have a bore cleaner and lube you trust, keep using it.
LR55
Breaking in a New Barrel and Cleaning - lwminton - 02-25-2016
ppierceall Wrote:I just ordered a new 6.5 Grendel Upper from Precision Firearms - For those who compete what is your procedure of breaking in a new barrel and cleaning. With my AR15 I use a bore snake with Gun Scrubber and G96. But I am sure with my 6.5 set up there may be a better way.I use Bore Tech Eliminator, but whatever you use to final clean get a can of WIPE-OUT foam cleaner. When you are done shooting spray it up the warm barrel - it coats the entire bore. I let a little get into the chamber and lower the bolt on it. By the time you get home, run a patch down and most of the gunk and some of the copper will be gone. Finish with Bore Tech if you like.
Breaking in a New Barrel and Cleaning - din - 02-26-2016
I am entirely the wrong person to answer this. My break-in consists of shooting the gun, and cleaning consists of dropping a bore snake down the pipe occasionally.