+- 6.5 Grendel Forum (https://65grendel.com)
+-- Forum: 6.5 GRENDEL DISCUSSION FORUMS (https://65grendel.com/forumdisplay.php?fid=3)
+--- Forum: 6.5 Grendel Bolt Actions & Single Shots (https://65grendel.com/forumdisplay.php?fid=17)
+--- Thread: Howa 1500 scout project (/showthread.php?tid=21873)
Howa 1500 scout project - Redbaron - 08-20-2020
I've started putting together a scout rifle in 6.5G using a Howa barreled action. I think I've got most of the components figured out except for the magazine. I'm not sure if I want to stick with the factory magazine and upgrade the bottom metal, or go with an upgraded bottom metal/blind magazine set up. My hang up is in carrying the rifle. On my other scouts I find myself carrying the rifle in hand gripping it around the action/magazine, and I wasn't sure if the factory mag would get in the way of that too much.
Are there any practical reasons to retain the factory mag setup over a blind magazine setup?
Here's what I've got and what I'm planning on the build so far:
B&C Sporter stock
Vortex Crossfire II 2-7x Scout Scope
Send off to gunsmith for:
Cut barrel (it's the heavy contour) back to 18" and thread for muzzle device
Install small rail section on barrel for scope mount
Attach backup irons...somehow
Howa 1500 scout project - Stinky Coyote - 08-20-2020
i think the better base for this project would be the ruger american ranch with it's 16.1" heavy threaded barrel and detachable 10 round AR magazine...this would just require a front, your barrel mount scout rail, and rear sight which could utilize the stock rail, or remove the stock rail
but you're not going to find a reasonable magazine solution for scout concept imo, the ruger is most of the way there