05-15-2023, 09:08 PM
Hey guys. Lurk every once in a while. Haven't been too active here as of late.
Picked up an Oregunsmithing bottom metal a while back and finally got around to putting it in.
First problem - floor plate wouldn't latch all the way. When loading the magazine, it would pop open. Finally figured out that the B&C stock was inlet a few thousandths too deep. Easy fix with a thin washer under the rear part of the bottom metal.
Now the issue is the last round in the mag won't pop up to feed. The others will feed fine. The last round goes nose down or lays flat.
I'm thinking the follower is hanging up on something.
Anyone else experience this issue?
Picked up an Oregunsmithing bottom metal a while back and finally got around to putting it in.
First problem - floor plate wouldn't latch all the way. When loading the magazine, it would pop open. Finally figured out that the B&C stock was inlet a few thousandths too deep. Easy fix with a thin washer under the rear part of the bottom metal.
Now the issue is the last round in the mag won't pop up to feed. The others will feed fine. The last round goes nose down or lays flat.
I'm thinking the follower is hanging up on something.
Anyone else experience this issue?
