09-03-2018, 01:20 AM
Shooting Hornady Black. Shot 3 at 25yds just to break in. Ran a bore snake with a little solvent after every shot for the first five, then after every 3. Went to a 100yds and was like 6" high. Went down 15 clicks and it looked good to me, 2" high. Put up 2 new targets at 100 and shot the 5 rounds on the left. It almost looked like 3 holes. Turned 2 clicks to the right, then shot the right target 4 times. Again, only looks like 3 holes, but they're all there. Probably the most accurate gun I've shot right out of a box. I've never really shot anything, or had a scope past 9 magnification before. Was using 18x and I'm sure I'll use 24x when I go to 200 and beyond. Only major problem I had is after about the 5th and 10th round, the magazine automatically ejected out the bottom. Not hard, just kind of fell out. I was using two 10 rounders, and I'm not sure if they were the same mag because I was just loading 1 round at a time and alternating them. Im going to inspect the mag catch assembly, but I'm also guessing that its overgassed since its a PSA upper. Didn't have the problem the last 10 rounds, so I guess it just might be break in gremlins.