Installing Mag Release Into DIP Bottom Metal

Linear Mode

Installing Mag Release Into DIP Bottom Metal

Yama

Offline

Junior Member

Posts: 36
Threads: 6
Joined: Jul 2018

#3

01-08-2019, 03:30 PM

Yup, as per the instructions, I used a tooth pick; worked like a charm! Don't forget some blue thread locker on that set screw.

Find

Reply

« Next Oldest | Next Newest »

Messages In This Thread

Installing Mag Release Into DIP Bottom Metal - by ripcord - 01-05-2019, 04:42 PM

Installing Mag Release Into DIP Bottom Metal - by A5BLASTER - 01-05-2019, 04:49 PM

Installing Mag Release Into DIP Bottom Metal - by Yama - 01-08-2019, 03:30 PM

Installing Mag Release Into DIP Bottom Metal - by cwlongshot - 01-08-2019, 04:52 PM

Installing Mag Release Into DIP Bottom Metal - by Yama - 01-08-2019, 06:20 PM

Installing Mag Release Into DIP Bottom Metal - by smcdurmon - 02-20-2019, 06:25 PM

Installing Mag Release Into DIP Bottom Metal - by legaleagle47 - 08-17-2019, 03:45 PM

Installing Mag Release Into DIP Bottom Metal - by HokeyPokeyKid - 08-17-2019, 05:54 PM

Installing Mag Release Into DIP Bottom Metal - by Bearcat74 - 08-17-2019, 07:09 PM

Installing Mag Release Into DIP Bottom Metal - by legaleagle47 - 08-17-2019, 10:49 PM

Installing Mag Release Into DIP Bottom Metal - by HokeyPokeyKid - 08-17-2019, 10:56 PM

Installing Mag Release Into DIP Bottom Metal - by Kswhitetails - 08-18-2019, 02:09 AM

Installing Mag Release Into DIP Bottom Metal - by A5BLASTER - 08-18-2019, 02:55 AM

Installing Mag Release Into DIP Bottom Metal - by Fess - 08-18-2019, 03:33 AM

Installing Mag Release Into DIP Bottom Metal - by Bearcat74 - 08-18-2019, 10:14 PM

Installing Mag Release Into DIP Bottom Metal - by Waynejessie - 08-21-2019, 02:33 AM

Installing Mag Release Into DIP Bottom Metal - by TropicalVibe - 02-24-2021, 12:17 AM

View a Printable Version

Forum Jump:

Users browsing this thread: 1 Guest(s)