02-16-2019, 05:15 PM
I use a 6mm ppc die sizing down to 6mm then use the Redding 65grendel bushing die from there on.
I back the ppc die off around 75 thou and set it when it will chamber by dropping the bolt down with the upper in the vertical position.
Using the bushing die first leaves a flare at the top of the necks and doesn't seem to work as well with the ppc full length die.
I back the ppc die off around 75 thou and set it when it will chamber by dropping the bolt down with the upper in the vertical position.
Using the bushing die first leaves a flare at the top of the necks and doesn't seem to work as well with the ppc full length die.