My semi-custom 6mm Grendel bolt action build

[bj139]

Not to side track but have a question.

If I wanted too get a 6 grendel barrel made up. Can I take my Redding bushing size die and just change out the bushing to the proper size bushing and do a simple neck down and fire form to 6 grendel.

Never have done this before but was hoping it would be that simple and allow me too use already owned dies and brass.

Will this work?

Yes. I do the sizing down in one step with lots of RCBS Case Lube 2 applied liberally inside and outside of the neck with a cotton swab.

I size 6.8mm cases to 6.5mm with a .285 bushing and then a .267 bushing to get to 6mm. I did about 20 cases and all were good.