03-01-2019, 07:22 AM
Put together my first Grendel build.
[ATTACH=CONFIG]13798[/ATTACH]
BCA 18" SS upper, that I stripped down, lapped the receiver, bedded the barrel extension, replaced the gas block with an adjustable, replaced the flash hider with a SJC Titan, and polished everything on the BCG.
Anderson lower, with a Luther MBA3 stock, rubberized grip and an Elftmann Tactical Match trigger set as light as it will go. Vortex Diamondback Tactical 6-24 scope.
Crown from the factory was absolute crap.
[ATTACH=CONFIG]13795[/ATTACH]
First groups were grendel shotgun. So I recrowned it by hand.[ATTACH=CONFIG]13796[/ATTACH] to remove all the gouges and burrs at the Crown. Then shot this group at 50 yards in 10 to 30 mph gusting winds.
[ATTACH=CONFIG]13797[/ATTACH]
Can't wait to shoot it at longer range in reasonable weather. But so far it has functioned flawlessly.
[ATTACH=CONFIG]13798[/ATTACH]
BCA 18" SS upper, that I stripped down, lapped the receiver, bedded the barrel extension, replaced the gas block with an adjustable, replaced the flash hider with a SJC Titan, and polished everything on the BCG.
Anderson lower, with a Luther MBA3 stock, rubberized grip and an Elftmann Tactical Match trigger set as light as it will go. Vortex Diamondback Tactical 6-24 scope.
Crown from the factory was absolute crap.
[ATTACH=CONFIG]13795[/ATTACH]
First groups were grendel shotgun. So I recrowned it by hand.[ATTACH=CONFIG]13796[/ATTACH] to remove all the gouges and burrs at the Crown. Then shot this group at 50 yards in 10 to 30 mph gusting winds.
[ATTACH=CONFIG]13797[/ATTACH]
Can't wait to shoot it at longer range in reasonable weather. But so far it has functioned flawlessly.