|
My first build.
|
03-04-2019, 04:27 AM
I used a ball bearing, hot glued into a wire nut, chucked up on my hand drill. Started with 220 grit lapping compound, then finished with 600 grit lapping compound. Then you orbit the drill as you spin the ball to keep the grit in play and prevent the ball from getting grooved in a single spot. I used a ball diameter that would give me roughly a 30 deg chamfer at the lands.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
My first build. - by trace - 03-01-2019, 07:22 AM
My first build. - by shooter545 - 03-01-2019, 10:54 PM
My first build. - by trace - 03-02-2019, 12:48 AM
My first build. - by shooter545 - 03-02-2019, 03:02 PM
My first build. - by Glockpride - 03-02-2019, 03:43 PM
My first build. - by trace - 03-03-2019, 01:21 AM
My first build. - by Yissnakk - 03-04-2019, 12:03 AM
My first build. - by trace - 03-04-2019, 04:27 AM
My first build. - by Yissnakk - 03-09-2019, 03:59 PM
My first build. - by trace - 03-10-2019, 06:50 PM
My first build. - by snell - 03-10-2019, 11:21 PM
|
