M4 billet upper from Antares arms
Hogue Overmold Red Lava grip and stock
Trinity force buffer tube Mil spec (fits the Hogue well, but was the hardest tube I have installed yet. The wrench did not fit right but still grabbed enough to snug the castle nut.)
Tool-craft BCG
Anderson Manufacturing Lower/Magpul trigger guard (I had to trim the tab on the grip to fit with the trigger guard)
Anderson manufacturing LPK (worked on the detent pins with my worksharp knife sharpener to round them a bit.)
CMC single stage trigger
Anderson manufacturing rifle length tube
Trinity force 15" forend (so far this is nice)
20" GM group buy barrel
Have an Odin works low pro GB on the way.
Hogue Overmold Red Lava grip and stock
Trinity force buffer tube Mil spec (fits the Hogue well, but was the hardest tube I have installed yet. The wrench did not fit right but still grabbed enough to snug the castle nut.)
Tool-craft BCG
Anderson Manufacturing Lower/Magpul trigger guard (I had to trim the tab on the grip to fit with the trigger guard)
Anderson manufacturing LPK (worked on the detent pins with my worksharp knife sharpener to round them a bit.)
CMC single stage trigger
Anderson manufacturing rifle length tube
Trinity force 15" forend (so far this is nice)
20" GM group buy barrel
Have an Odin works low pro GB on the way.