6.5 Grendel Forum › 6.5 GRENDEL DISCUSSION FORUMS › 6.5 Grendel NFA Center v
SBR Engraving Dimensions?

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
SBR Engraving Dimensions?
Pugsbrew Offline
Junior Member
**
Posts: 23
Threads: 7
Joined: Mar 2018
#3
08-25-2019, 05:10 PM
ricsmall Wrote:Should be 1/16” in height.

Thanks. I saw at least two sites that had 11/16". They must have used the same info. ATF site says 1/16" min.

https://www.atf.gov/firearms/firearms-gu...n-overview
Find
Reply


Messages In This Thread
SBR Engraving Dimensions? - by Pugsbrew - 08-25-2019, 02:05 PM
SBR Engraving Dimensions? - by ricsmall - 08-25-2019, 02:28 PM
SBR Engraving Dimensions? - by Pugsbrew - 08-25-2019, 05:10 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)