The stock has an open channel in the forend, so the easiest way to finish it off is to epoxy the end back on after you remove the section you want. I just drilled a few holes for the JB Weld to hold.
I'll use the small hand held belt sander to shape it up.
[ATTACH=CONFIG]15011[/ATTACH]
[ATTACH=CONFIG]15012[/ATTACH]
[ATTACH=CONFIG]15014[/ATTACH]
I'll sand the forend down to a slimmer shape.
[ATTACH=CONFIG]15015[/ATTACH]
I'll use the small hand held belt sander to shape it up.
[ATTACH=CONFIG]15011[/ATTACH]
[ATTACH=CONFIG]15012[/ATTACH]
[ATTACH=CONFIG]15014[/ATTACH]
I'll sand the forend down to a slimmer shape.
[ATTACH=CONFIG]15015[/ATTACH]