12-09-2021, 08:42 PM
(This post was last modified: 12-09-2021, 09:08 PM by Happy2Shoot.)
I shot it today!
No accuracy to report just used a red dot at 50 yds.
Definitely needs a cheek riser.
Needs more polishing.
Feed ramp ridge edge is sharp and was scraping the brass near the base as I fed rounds causing it to jam a little.
Going to gently grind that ridge with a green rubber cone with a Dremel then Flitz it.
No accuracy to report just used a red dot at 50 yds.
Definitely needs a cheek riser.
Needs more polishing.
Feed ramp ridge edge is sharp and was scraping the brass near the base as I fed rounds causing it to jam a little.
Going to gently grind that ridge with a green rubber cone with a Dremel then Flitz it.