01-27-2022, 03:40 PM
Old Bob Wrote:I believe the 35 inch lbs (Howa's spec) is for the original plastic bottom "metal." You should be able to easily torque DIP aluminum or Oregunsmithing's flat bottom metal up to 55 inch lbs.
Im sure you can, but this was direct from Wayne after he put it together. His bottom metal too.
With metal bottom metal and a bell and carlson or any other stock with metal pillars or bedding block I go to 50-55ft lbs. Even with a couple of stocks that are solid epoxy, I use 50ft lbs. Seems light to go with 35 but there is an acceptable range.
Some people (I think especially with the ruger angled front screw) adjust their torque to tune their groups. I have never done this myself but try to consistently set the torque. Proper bedding should alleviate any potential changes due to torque.