01-23-2023, 05:42 AM
Answer to your question is yes. I have mdt chassis's (plural), one of which is on my howa.
They take mil spec or comm, threads are the same. I use milspec, and onto it (them) I have the luth-AR mba's, Like this combo also.
There is a small setscrew underneath on the mdt, you tighten that into the buffer when you have it on and straight. Also note that the setscrew sometimes can stick out a bit, and be a source of scratches on your hand, I put a small piece of duck tape over it in those cases.
O, I also use a buffer lock nut/castle nut on it, to ensure it stays tight.
I think (it is late at night...) I used the LSS version for the howa, but the XL will work also, just be a tad longer is all.
They take mil spec or comm, threads are the same. I use milspec, and onto it (them) I have the luth-AR mba's, Like this combo also.
There is a small setscrew underneath on the mdt, you tighten that into the buffer when you have it on and straight. Also note that the setscrew sometimes can stick out a bit, and be a source of scratches on your hand, I put a small piece of duck tape over it in those cases.
O, I also use a buffer lock nut/castle nut on it, to ensure it stays tight.
I think (it is late at night...) I used the LSS version for the howa, but the XL will work also, just be a tad longer is all.
"Down the floor, out the door, Go Brandon Go!!!!!"