I'm starting to load for my Grendel. I measured some brass after sizing and found all of it was 1.520. Hornady says max is 1.516 with trim of 1.506.
I found three I hadn't sized and the were about the same as unfired rounds at 1.510.
I think my Hornady dies are streching my brass. Has anyone else seen this?
I'll lube my brass better the nextime and I'll look at lubing the necks.
Any other suggestions?
Thanks. Dave
I found three I hadn't sized and the were about the same as unfired rounds at 1.510.
I think my Hornady dies are streching my brass. Has anyone else seen this?
I'll lube my brass better the nextime and I'll look at lubing the necks.
Any other suggestions?
Thanks. Dave
Comment