Maker Bullets

[Clove8]

Does maker have any retailers for their bullets. I am looking for some 120 tipped T. rex

[FLshooter]

$36/50 on their website.

[A5BLASTER]

I think it's direct order only from his website.

Make a account and place your orders through him. You earn points and can get free bullets with enough points.

[CJW]

Think A5Blaster is right.....

They are close to where I live in Atlanta.

Chuck

[Clove8]

$36/50 on their website.

Out of stock.

[CJW]

Call them, they make them for you.

[A5BLASTER]

Out of stock.

Yea give him a call, been a good guy to do business with so far for me.

[RobertFL]

I just got 40 rounds of 85 grain from Maker (Paul) this afternoon. They look like they will open up and do some damage on some hogs. Some heavier TREX bullets may be what I order next, I have a AR15 based Grendel so the OAL may be an issue on longer Heavier bullets???

[Bigs28]

I shoot the 110g and it shoots very well. Paul has recommended the lighter bullets as well.

[Clove8]

Surely they cannot be any longer than the Barnes TTSX 120g. Those babies are long.

[A5BLASTER]

Surely they cannot be any longer than the Barnes TTSX 120g. Those babies are long.

It's not so much the length. It's where the ojive on his bullets falls in relation to the length.

Most of his bullets are cut for creedmoor.

That said the 85 to 110 grain should work fine.

I haven't gotten any of the other weight bullets because the 85 grainers is all I need from his line up of bullets.

If I need a 120ish copper bullet I will just run the 127 LRX Barnes with its lower expansion limit then the ttsx,tsx bullets.

[Randominator]

Contact Paul Hendrixson through Facebook or Messenger and he will ensure the bullets you want will be in stock. He will also supply a discount code.
I use his bullets designed for subsonic in my 300 Backout.

This bullet was shot through 7 one gallon milk jugs filled with water at 1060 fps. from 20 yards.



The same bullet dropped this buck this fall at a distance of 126 yards. Complete pass through and the deer only traveled 40 yards.

[kev500]

Does anyone know what is the min fps for expansion also BC of 120 and 110 grain

[A5BLASTER]

Does anyone know what is the min fps for expansion also BC of 120 and 110 grain

The 85 grain tipped Trex was tested and found to be at the 1600fps range for min expansion. His site says .370 G1 bc

Don't know about the 110 or 120 grainers. Might have to give him a call. He will probably have the data your looking for.

[rickOshay]

The Maker 85, 95, and 110 gr are included in the Lead free projectiles thread here:

http://www.65grendel.com/forum/showthread.php?13324-Lead-Free-Projectiles-for-the-6-5-Grendel

Minimum velocities are estimated from gel results.