Feed ramp/ lugs question

[Bretandry]

Hello folks.
What is your personal practice on a new drop in barrels feed ramps and lug area polishing and smoothing? Is there a proven practice on the Grendel due to it's larger case diameter? Are there areas to pay more attention to for irregularities? Thanks for any advice in advance.

[VASCAR2]

[603 Country]

[LRRPF52]

[LRRPF52]

[Bretandry]

Thank you sir...Got it a standard polish job on the ramps and the corresponding edges with attention to not altering geometry just cleaning any machine marks..Correct?

[Bretandry]

I have been lapping and bedding barrels on all my builds for a while now thanks again and yes i agree it's a good practice no down side to doing it (got that practice from Joe Carlos). Just an FYI to remove a bedded barrel "Goof Off" super glue remover gets loctite to release. A decent dousing a few times before disassembly is all you need.