DIP Bottom metal

[BIGHORN66]

OK Guys,

Who wants to install my mag release in my DIP bottom metal?
I will gladly pay for shipping both ways and your time.

I have wasted an hour trying to get it and all I have accomplished is getting ticked off and shooting the spring across the room several time.

Feel free to post here or PM me.

Thanks.

Shawn

[Frontier Gear]

I’ll do it. Where are you located?

[grayfox]

Lol!! I shouldn't laugh it is a pain....
I'll help you out if nobody else will.
PM me if you want...

[Frontier Gear]

By the way, a Q-tip makes for the perfect slave pin.

[HokeyPokeyKid]

By the way, a Q-tip makes for the perfect slave pin.

I found the Q-tip worked better than a toothpick.

[A5BLASTER]

I used a Allen key and then drove the pin in with a roll punch and ball peen hammer driving the Allen key out with the keeper pin.

It was still kind of pain in the rear but worked. I have Hokies bottom metal not the DIP maybe that's why it wasn't as bad.

[Chipj4]

By the way, a Q-tip makes for the perfect slave pin.

That's what I finally ended up using as well. I dorked around with a toothpick for an hour before getting the idea.

[LittleBigHammer]

I can't remember who suggested it (F.G. maybe?), but get a 2 gal. ziplock bag and do your assembly inside of that. it will greatly reduce the size and scope of spring and small part searches. I wish I had thought of that about a hundred small parts ago....

[Taz575]

Yup, did mine with a q tip as a slave pin last night. Easy Peasy!

[BIGHORN66]

Thanks for the Q-tip suggestion.
Worked like a charm.
Thanks all.

[Frontier Gear]

Glad that you were able to get it.

[Chipj4]

The ingenuity of desperation