If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
That would be correct, as long as that is the barrels measurement at the gas block location. Set screw or clamp-on are the choices. Some barrels have a milled spot on the bottom of the barrel for the set screw type. Some have dimples. Some barrels do not have any landings, so some use the clamp-on for those types of barrels.
I called AA and asked, the barrel has no landing or dimples. I have heard that the set screw type may cause harmonic distortion or a dead spot in the barrel harmonics, so the clamp-on is preferred. I'm going to just use the set screw and not worry about it.
""Come taste my Shillelagh you goat-eatin bastard!""
Comment