If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
What are the recommended gas ports diameter sizes for 20" (Rifle gas tube length), 18" (Rifle and Mid gas tube length) and 16" barrels (Carbine gas Tube)?
Thanks.
Ok, so here is the setup. I have a Sabre Defense M4 upper, 16", carbine gas, stock carbine spring and H buffer (the spring and buffer can certainly be replaced). I am trying to decide to what length I want to cut it back to, 14.5" or 10.5". I plan to run it with my Rugged Surge .30 cal suppressor. Not wanting to
General speaking, if going off of Bill Alexander's extensive developmental work on setting up gas ports:
20" RLGS .0935" (like on a 5.56)
18" MLGS .076"
16" MLGS .076"
16" CLGS .0625"
My Faxon 12" CLGS group buy is .068", runs great suppressed and unsuppressed so far.
These barrels and ports will generally drop onto an existing lower whether it has a carbine RET, 2.0 ounce buffer, and Mil-Std carbine spring or a rifle RET/spring/5.1 ounce buffer.
NRA Basic, Pistol, Rifle, Shotgun, RSO
CCW, CQM, DM, Long Range Rifle Instructor
6.5 Grendel Reloading Handbooks & chamber brushes can be found here:
Comment