If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I made an adapter for my Magnetospeed to clamp onto a pic rail section. A quick release, piece of aluminum angle and a couple of .380 cases. Drilled the quick release and bolted it up. Works great. Can do velocity and accuracy testing at the same time.
Monty,
I came all the way from youtube, joined the forum today, just to thank you! Sort of Tactical gave you a shout out https://youtu.be/meW_Mmh4NU8. I had to build two different ones to accommodate my 13.5 & 15 inch HGs. Don't know if if the 15" will work (gap between magneto and cleaning rod is about 0.765), might have to play around with the sensitivity. side2.jpg side1.jpg
Anyways, Thank You for sharing!
Last edited by FrgnMetalJoe; 02-09-2021, 11:07 PM.
Monty,
I came all the way from youtube, joined the forum today, just to thank you! Sort of Tactical gave you a shout out https://youtu.be/meW_Mmh4NU8. I had to build two different ones to accommodate my 13.5 & 15 inch HGs. Don't know if if the 15" will work (gap between magneto and cleaning rod is about 0.765), might have to play around with the sensitivity.
[ATTACH=CONFIG]17524[/ATTACH]
[ATTACH=CONFIG]17523[/ATTACH]
Anyways, Thank You for sharing!
Those look great, and thanks for checking out my You Tube channel.
Comment