Presenting the HuntTXhogs Night Hunter

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts
  • HuntTXhogs
    Warrior
    • Jan 2014
    • 549

    Presenting the HuntTXhogs Night Hunter

    Old member (Bennybone) with a new forum handle here

    Took in a factory Alexander Arms M4 upper, here is the "before" photo



    Performed the following waredrobe changes:
    • Rifle Length DoubleStar handguard, smooth varmint style contour
    • Yankee Hill low profile gas block to allow for the handguard to slide over and conceal
    • Installed 2 picatinney rails into the available slots on the front of the handguard
    • Pulled the barrel and polished the feed ramps
    • Used a 1/2x28 TPI Kaw Valley muzzle brake, rethreaded to 9.16x24, honed out a crush washer
    • Custom laser etched dustcover, outside and inside
    • BCM Mod3 Large Latch charging handle
    • Used a Yankee Hill beauty ring, it was too large so I milled it down and press fitted with locking agent
    • Reassembled - it can wear either an LW15 polymer M4 lower or A2 lower.


    "After" photos:


  • HuntTXhogs
    Warrior
    • Jan 2014
    • 549

    #2



    Comment

    • HuntTXhogs
      Warrior
      • Jan 2014
      • 549

      #3
      And the Night Hunter Part, actually this is a daylight capable scope as well - So a Night/Day Hunter

      Sightmark Photon 3.5x Digital NV riflescope
      UNV20IR - IR illuminator




      Field testing this Spring.....

      HTXH
      Last edited by HuntTXhogs; 01-26-2014, 08:40 PM.

      Comment

      • Heywood
        Warrior
        • Aug 2013
        • 121

        #4
        That's some serious hardware. Good transformation.
        quis posuit in mea ocreis bologna!

        Comment


        • #5
          Nice, very nice. Adding the YHM end ring is a nice touch. I'm assuming the muzzle brake was originally for a 223, did you have to drill it out for the 6.5 bullet?

          Comment

          • HuntTXhogs
            Warrior
            • Jan 2014
            • 549

            #6
            Originally posted by Whelenon View Post
            Nice, very nice. Adding the YHM end ring is a nice touch. I'm assuming the muzzle brake was originally for a 223, did you have to drill it out for the 6.5 bullet?
            Yes Sir, process is covered here. http://www.65grendel.com/forum/showt...zle-brake-HELP

            Thanks for the compliments guys.

            Comment

            • Overwatcher

              #7
              Nice looking rig,you'll have to keep us updated on how your photon works.
              Gets me all excited to see a lot more people getting into NV!

              Comment

              • HuntTXhogs
                Warrior
                • Jan 2014
                • 549

                #8
                Originally posted by Overwatcher View Post
                Nice looking rig,you'll have to keep us updated on how your photon works.
                Gets me all excited to see a lot more people getting into NV!
                Here is a video review I did of the basic functionality of the Photon.

                Phase 2 of field testing will be getting pigs down with the Grendel, I will keep you all posted!

                Comment

                • Overwatcher

                  #9
                  Okay,have actually seen almost all your videos!
                  Good stuff,thanks for the uploads.

                  Comment

                  Working...
                  X